My Account / Order Status
For contact information
(Your shopping cart is empty)
Vibra-Stop Mid Range outboard motor backing pad (pair) - Model MDRNG-BP
Usually Ships in 24 Hours
Vibra-Stop outboard motor backing pad for use with outboard motors from 30HP-115HP. Video shows our small pads in action - suggest you watch in full screen mode!
Vibra-Stop - feel the difference!
Dimensions and fitting information:
Width.............. 4 1/8 inches (each pad, at widest part)
Length............. 12 1/2 inches
Thickness........ 5/8 inch
Note: Check distance on center between top mounting bolts on your motor - it must be at least 6 1/2 inches to install these pads, it can be wider but not narrower.
Feel the Difference!
Backing Pad Installation Guide:
* Backing pads are designed so that the sharp edge of the pads sit against the transom of the boat, the radius edge is on the motor side.
* Recommended torque setting is between 28-34 ft/lbs - this should be rechecked every 100 hours. Ideal torque is 30 ft/lbs. Do not over tighten your mounting bolts!
* Anodized aluminum key sets must be fitted for engines over 135 HP with slots for the bottom mounting bolts rather than holes.
* It is important to use either nyloc or double lock nuts to secure the engine mounting bolts, spring or lock washers are not suitable for the Vibra-Stop system to secure the engine mounting bolts.
Substantial reduction in vibration levels on large and small boats
Excellent memory retention - will not compress over time
Excellent UV properties - will not break down in the sun
Will not absorb water
Quick and easy to install
with questions or for assistance in choosing the right Vibra-Stop system for your boat
Browse for more products in the same category as this item:
Vibra-Stop Motor Backing Pads
Send Us Feedback
Cure Outboard Motor Vibration
Boat ladder parts
Search Engine Optimization
Search Engine Marketing
test message here