My Account / Order Status
For contact information
(Your shopping cart is empty)
Vibra-Stop outboard motor backing pad (pair) - Model VRD-BP
Usually Ships in 24 Hours
Vibra-Stop outboard motor backing pads for use with Mercury Verado only. Note the 200 HP Verado requires our V6-BP, NOT this pad which is for the 300 and 350 HP models. Video shows some of our small pads in action - suggest you watch in full screen mode.
Feel the difference with Vibra-Stop!
Custom motor backing pad exclusively for use with Mercury Verado (300 & 350HP)
Reduces resonance and vibration induced noise
Must be installed with Anodized Aluminum Key set p/n AAK-MERVRD
Consider using with Vibra-Stop bushing kit p/n FBBK for the ultimate in vibration reduction!
Feel the Difference!
Backing Pad Installation Guide:
* Backing pads are designed so that the sharp edge of the pads sit against the transom of the boat, the radius edge is on the motor side.
* Recommended torque setting is for Mercury Verado installation is 38 ft/lbs. Do not over tighten your mounting bolts!
* Anodized aluminum key sets must be fitted for Mercury Verado engines with slots for the bottom mounting bolts rather than holes p/n AAK-MERVRD
* It is important to use either nyloc or double lock nuts to secure the engine mounting bolts, spring or lock washers are not suitable for the Vibra-Stop system to secure the engine mounting bolts.
Substantial reduction in vibration levels on large and small boats
Excellent memory retention - will not compress over time
Excellent UV properties - will not break down in the sun
Will not absorb water
Quick and easy to install
These backing pads must be installed with Anodized Aluminum Keys p/n AAK-MERVRD
with questions or for assistance in choosing the right Vibra-Stop system for your boat
Browse for more products in the same category as this item:
Vibra-Stop Motor Backing Pads
Send Us Feedback
Cure Outboard Motor Vibration
Boat ladder parts
Search Engine Optimization
Search Engine Marketing
test message here